1930 Chevy
Because your chassis is the backbone of your street rod, LRS prides itself in fabricating one of the finest quality street rod frames in the industry. Our frames are uniquely fabricated from flat 11 gauge P&O plate. This allows us to weld the body mounting nuts inside the frame rails instead of using nut zerks that others use. We have our pieces laser cut so we are ensured of getting the same piece each time. We then fit the pieces on our rail jigs, square them and weld. All welds are then ground and inspected to verify that they have complete penetration and no porosity. They are then sanded with 50 grit to prep it for finishing. The rails are placed into our rotisserie frame fixture and tack welded to the fixture to eliminate movement while the frame is constructed and T.I.G. welded. Sounds like a lot of work? Yes, it is, but this is the way we choose to build your quality chassis. From start to finish, it takes 6 to 7 days to complete, depending on the number of coffee and smoke breaks we take! Many options are available for your completed chassis. Below are just a few ways to order; however, please feel free to call us with any other ideas you may have. We look forward to doing business with you. Please note that our completed chassis prices include many options that other shops do not.
Complete Rolling Chassis
$ 8,135.00
Complete hub to hub drop tube axle or I beam, front 4 bar or hair pin, cross steering complete with new Vega box, front disc brakes, engine mounts, master cylinder mount with dual master cylinder, brake pedal, rear 4 bar (triangulated or parallel), 9" housing with axles (28 or 31 spline), 10" drum brakes and open 3rd member (any gear ratio), rear coil over shocks, rear panhard bar (if required).
Upgrade Options:
| Power Brake Option |
280.00 |
Pro-street option |
726.00 |
| 3/8 rotor, 360 degree back plate, Wilwood calipers |
483.00 |
Front mono leaf spring (plain) |
75.00 |
| above with aluminum finned backing plates |
739.00 |
Front mono leaf spring (chrome) |
199.00 |
| show chrome on front I beam |
294.00 |
C-notch rear |
150.00 |
| chrome front end option |
800.00 |
C-notch front |
150.00 |
| Rear SVO disc with emergency brake |
302.00 |
Stretch front frame rails (2,3,4,5 or 6 inches) |
330.00 |
| brake line kit installed (AN fittings) |
738.00 |
|
|
|
|
|
Complete Chassis with Independent Front Suspension using Coil Overs
$8,240.00
Complete hub to hub Heidt's IFS front with Wilwood 4 piston calipers, tubular upper and lower control arms, front coil over shocks, dual master cylinder, brake pedal, rear 4 bar (triangulated or parallel), rear coil over shocks, Ford 9" housing and axles (28 or 31 spline), 10" drum brakes, open third member (any ratio).
Economy Chassis
(Includes the following T.I.G. welded to chassis)
Front Panhard Bracket Master Cylinder Mount
Vega Steering Box Mount Rear Panhard Bar Mount
Front 4-Bar Brackets Rear 4 Bar Front Hanger
Upper Front Shock Towers Engine Mounts (SB Chevy, Ford)
$ 3,530.00
Perimeter Frame
$ 2,700.00
Shipping and Crating Charges Additional
Prices & Design Subject to Change Without Notice
Ph: 417-466-4883
Fax: 417-466-2556